Table of Contents
Advertisement
h. Processors and memory blanks (if applicable)
CAUTION:
To prevent damage to the processor pins when replacing a faulty system board, ensure that
you cover the processor socket with the processor protective cap.
i.
Memory modules
and memory module blanks
j.
Network daughter card
Steps
1. Disconnect all cables from the system board.
CAUTION:
Take care not to damage the system identification button while removing the system board from
the chassis.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
2. Holding the system board holder, loosen the release pin, slightly lift the system board, and then slide it toward the front of
the chassis.
Sliding the system board toward the front of the chassis disengages the connectors from the back of the chassis slots.
3. Lift the system board out of the chassis.
Figure 73. Removing the system board
Next steps
Install the
system
board.
Installing the system board
Prerequisites
Follow the safety guidelines listed in
Steps
1. Unpack the new system board assembly.
CAUTION:
Do not lift the system board by holding a memory module, processor, or other components.
112
Installing and removing system components
Safety instructions
on page 55.
Advertisement
Table of Contents
