Table of Contents
Advertisement
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE:
If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Network Settings.
Network Settings screen details
The Network Settings screen details are explained as follows:
About this task
NOTE:
The XC Series Appliance and XC Core System does not support the NVDIMM-N, RAID, or UEFI settings.
Option
Description
PXE Device n (n
Enables or disables the device. When enabled, a UEFI PXE boot option is created for the device.
= 1 to 4)
UEFI PXE
Enables or disables the device. When enabled, a UEFI PXE boot option is created for the device.
Settings
PXE Device n
Enables you to control the configuration of the PXE device.
Settings(n = 1 to
4)
HTTP Device n (n
Enables or disables the device. When enabled, a UEFI HTTP boot option is created for the device.
= 1 to 4)
HTTP Device n
Enables you to control the configuration of the HTTP device.
Settings (n = 1 to
4)
UEFI iSCSI Settings
You can use the iSCSI Settings screen to modify iSCSI device settings. The iSCSI Settings option is available only in the UEFI
boot mode. BIOS does not control network settings in the BIOS boot mode. For the BIOS boot mode, the option ROM of the
network controller handles the network settings.
NOTE:
The XC Series Appliance and XC Core System does not support the NVDIMM-N, RAID, or UEFI settings.
Viewing UEFI iSCSI Settings
To view the UEFI iSCSI Settings screen, perform the following steps:
About this task
NOTE:
The XC Series Appliance and XC Core System does not support the NVDIMM-N, RAID, or UEFI settings.
Steps
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
Pre-operating system management applications
41
Advertisement
Table of Contents
