NOTE:
While installing riser 1 B, press the tabs and hold the touch point to align the expansion card riser and the riser
guide pin on the system board.
3. Lower the expansion card riser into place until the expansion card riser connector is fully seated in the connector.
Figure 37. Installing the expansion riser 1A
Figure 38. Installing the expansion riser 2A
Next steps
1. Follow the procedure listed in
2. Install any device drivers required for the card as described in the documentation for the card.
Removing an expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in
82
Installing and removing system components
After working inside your system
Safety instructions
on page 56.
on page 55.