Table of Contents
Advertisement
Figure 89. Installing the M.2 SSD module
a. module connector (2)
b. screw (2)
c. module (2)
Installing the BOSS card
About this task
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
Steps
1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and
peripherals.
NOTE:
It is recommended that you always use a static mat and static strap while working on components inside the
system.
2. Open the system cover.
3. Hold the card by its edges and align the card connector with the connector on the system board.
CAUTION:
To prevent damage to the card, you must hold the card by its edges only.
4. Press the card-edge down until the card is fully seated.
5. Close the system cover.
6. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
132
BOSS card
Advertisement
Table of Contents
