2. Pushing both retention clips simultaneously, lift the processor heat sink module (PHM) out of the system.
3. Set the PHM aside with the processor side facing up.
Figure 28. Removing the processor and heat sink module
Next steps
1. Install the
processor heat sink
Removing a processor from processor heat sink module
Prerequisites
WARNING:
The heat sink may be hot to touch for some time after the system has been powered down. Allow the
heat sink to cool before removing it.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the
processor and heat sink module
Steps
1. Place the heat sink with the processor side facing up.
2. Insert a flat sled screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the
thermal paste seal.
3. Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
74
Installing and removing system components
module.
Safety instructions
Before working inside your system
.
on page 55.
on page 56.