Table of Contents
Advertisement
2. Follow the procedure listed in
3. If applicable, remove the
4. If applicable, disconnect the cables from the expansion card.
NOTE:
When removing a card from the riser 1, open the PCIe card holder latch. If applicable, remove the PCIe guide and
then remove the expansion card.
Steps
1. If applicable, lift the expansion card latches out of the slot.
2. Hold the expansion card by its edges, and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
Figure 39. Removing an expansion card from riser 1A
Figure 40. Removing an expansion card from riser 2A
3. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening and close the
expansion card latch.
Before working inside your system
air
shroud.
on page 56.
Installing and removing system components
83
Advertisement
Table of Contents
