Table of Contents
Advertisement
Figure 23. Installing the rear cover
Power module assembly
Removing power module assembly
Prerequisites
1. Follow the safety guidelines listed in the
2.
Remove the rear
cover.
3. Remove the
sleds.
4. Remove the
witness sled.
5. Remove the
power supply units.
Steps
1. Using a Phillips 2 screwdriver, loosen the two captive screws.
2. Pull the power tray along with the power module assembly (PDB) from the chassis.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
NOTE:
Support the power tray with both hands while sliding it out of the chassis.
Safety
instructions.
Installing and removing system components
35
Advertisement
Table of Contents
