Crestron TSS-470E Product Manual page 47

NOTES:
If the mounting bracket needs to be removed or repositioned, press the release tabs on
l
the inside of each zip rail while pulling its attached spring foot back.
If the WMK will be installed into a table or similar surface with an exposed underside,
l
the zip rails can be trimmed by cutting into the relief located on each rail. Trim the zip
rails only after the spring feet have been tightened to the surface.
5. Confirm that the mounting bracket is level before proceeding to attach the touch screen.
Attach the Touch Screen
To attach the touch screen to the WMK:
1. Route all necessary cables through the opening in the mounting bracket.
2. Connect all cables to the rear of the touch screen.
Product Manual — Doc. 9347A TSS-470E • 43