Schwinn 490e Service Manual page 68

5. Using a 6mm hex wrench, remove the hardware
(indicated by ovals) that attaches the Pedals and remove
them.
Note: To assist with re-assembly,
Pivot Pin
There is also a Wave Washer on the post from the
Pedal.
Note: With the Pedal removed, do not fully rotate the
Lower Handlebars or damage to the cables in the
Handlebars will occur.
6. Using a 6mm hex wrench, remove the hardware
(indicated by an oval) from the Legs and remove them.
Note: To assist with re-assembly, notice there is a Wave
Washer on the post from the Crank Arm.
X2
notice that the Pivot Pin is flush
with the outside of the Lower
Handlebar.
Pedal
6mm
Pedal
Leg
68
X2
B
C
X2
*
X2
*
6mm
Crank Arm
Leg
**