Schwinn 490e Service Manual page 27

Section 2 - Replacing the Split Cable
(Servo, Speed and Resistance) Assembly
Note: The Split Cable Assembly has a single connector on
one end that connects to the Sensor Hub, with the
other end having three cable connectors. The three
connectors go to the Servo Motor, Speed Sensor, and
Resistance Sensor.
Note: All Shrouds have been removed for clarity.
Make sure that power to the machine is discon-
nected before beginning this step.
1. Carefully disconnect the old Split Cable Assembly
Connector from the Sensor Hub.
NOTICE: Do not pinch or cut the cables.
2. Connect the single connector on the end of the new Split
Cable Assembly to the Sensor Hub.
NOTICE: Do not pinch or cut the cables.
3. Carefully disconnect the Servo Motor Cable
Connector.
NOTICE: Do not pinch or cut the cables.
4. Route the appropriate cable end of the new Split
Cable Assembly to the Servo Motor Connector, and
connect it.
NOTICE: Do not pinch or cut the cables.
Sensor Hub
Split Cable Assembly
(Servo, Speed and Resistance)
Servo Motor Cable
Servo Motor Cable
Connector
27
Split Cable Assembly
(Servo, Speed and
Resistance) Con-
nector
Servo Motor