Schwinn 490e Service Manual page 49

ELECTRICAL WIRING ROUTE DETAIL
- Resistance Sensor
9. Re-assemble the machine in the reverse order of when
the parts were removed.
10. Plug the power cord into the machine and wall outlet.
11. Power on the machine. After the Power-Up/Welcome
screen appears, use the Resistance Level Quick keys 25
and 1 to confirm that the magnet caliper moves properly
between resistance level 1 and 25.
12. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
GND
Do not use until the machine has been fully
assembled and inspected for correct
performance in accordance with the Owner's
Manual.
Speed Sensor
Resistance Sensor
SERVO
CABLE, CONNECTOR WIRE POWER
BROWN
CABLE ASSEMBLY, HUB
to MAST HARNESS
CABLE, SPEED SENSOR
WIRE ASSY, SPLIT CBL
RESISTANCE SENS, SPEED
SENSOR, & SERVO
DC POWER
BROWN
BLUE
SWITCH
INLET
49
SENSOR HUB
SENSOR HUB
LIFT MOTOR CONTROL
OFFLINE POWER SUPPLY
BLUE
BLACK
RED
WHITE
HANDLE BAR BUTTONS
LIFT CO