Schwinn 490e Service Manual page 21

6. The Console display shows the AUTO CAL_RESIS-
TANCE (Automated Calibrate Resistance) option. Push the
Start button.
Note: If the Pause/Stop button is pushed part way
through the calibration (exit), the new calibration is
not saved.
7. The console will display changing text and numbers for
approximately 30 seconds as the servo motor moves.
8.
The console display will change to "CNFRM C4095 AGC
xx".
9. Push the Start button to confirm and save the resistance
calibration values. The display will momentarily change to
"SAVING CAL", then display "AUTO CAL_RESISTANCE".
Calibration is complete.
Note: Pushing the Pause/Stop button will abort the
calibration process, with the new calibration values
not being saved, and the last saved calibration values
being restored.
10. Power off the machine.
11. Power on the machine. After the Power-Up/Welcome
screen appears, use the Resistance Level Quick keys 25
and 1 to confirm that the magnet caliper moves properly
between resistance level 1 and 25.
12. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully
assembled and inspected for correct
performance in accordance with the Owner's
Manual.
21