Schwinn 490e Service Manual page 31

5. Gently compress the sides of the Pivot Cap to release it
from the Inner Pivot Shroud.
6. Using a #2 Phillips screwdriver, remove the 2 screws
(indicated by ovals) from the Inner Pivot Shroud.
7. Tie a 60 cm (24 inch) long piece of wire or string to the
end of the Cable. This wire or string will be used to pull the
new cable through and out of the Lower Handlebar.
8. Using a 6mm hex wrench, remove the hardware
(indicated by ovals) that attaches the Pedals and remove
them.
Note: To assist with re-assembly,
Pivot Pin
notice that the Pivot Pin is
flush with the outside of the
Lower Handlebar.
Pivot Cap
Inner Pivot
Shroud
Pedal
Pedal
31
Sensor Hub to
Upper Handle-
bar Buttons
Cable
Lower Handlebar