Table of Contents
Advertisement
1159SBD0305A,
3-5. OTHER ADJUSTMENT
(1) Adjustment of the Scanner/Mirrors Carriage Position
Swing down the Front Door,
Release and swing up the Upper Half of the copier.
Remove three screws and the Rear Cover.
Remove four screws and the Upper Left Cover.
Remove one screw and the Upper Front Left Cover.
Swing down and lock the Upper Half of the copier.
Remove two scraws and the Original Width Scale.
Remove the SDH Glass. (EP1030F/EP1031F Only)
Remove the Original Glass.
OONAAS
ON
>
10. Remove one screw, one connector, and the control pane!.
11. Remove one screw and the Lock Release Lever.
12. Remove three screws and Panel Lower Cover.
1158D194AB
13. Temporarily secure the set screws of the Scanner Fixing
Brackets at the front and rear to the Scanner.
14, Fitthe Scanner/Mirrors Carriage Positioning Jigs between
the Scanner and Mirrors Carriage.
1159D198AB
15. Loosen the fixing bracket set screws and press the Mirrors
Carriage up against the Positioning Jigs and Scanner.
16. Tighten the fixing bracket set screws to the specified
torque.
1159D196AC
D-68
3-6. POWER SOURCE VOLTAGE ROOT-MEAN-SQUARE-VALUE-TO-MEAN-
VALUE CONVERSION TABLE
When using the testers, voltmeters, or multimeters which show only the mean value, not Rms values, carry
out the following procedure.
1.
Measure the line voitage.
2.
Referring to the Mean Value Chart corresponding to each voltage area, see the figure under the volt-
age obtained In step 1.
If the line voltage is 125 V and Rms value is 80 V, for example, the mean value is 53.5 V.
Therefore, It is recommended that the voltage be adjusted so that the mean value Is set as close to 53.5
V as possible.
MEAN VALUE
CHART FOR 115/120/127V AREAS
ras] [vs [ [or Toe [om [ve [on [8]
(= inininininininininin
am |v [ve [or [oe Pe [vo [os
MEAN
Pa ae me === [= =|]
Ped EN Cd cd dd
MEAN
oe |e | |e ee
ee ea
ear
oe ff
ee
MEAN
D-69
Advertisement
Table of Contents
