Table of Contents
Advertisement
3.
Set to Service Mode.
4,
To correct the A2 feeding direction zoom ratio, press the following keys in the indicated sequence:
Copy Quantity and Zoom Key @ two times; the Start Key one time and the Copy Quantity and Zoom
Key @ two times.
Re
1159D020AA
Press the Keys in order of [1], [2], 3},
[4], and [5].
1159D021AA
"A2" wilt appear in the Display Panel.
5.
Press the Start Key and press the Copy Quantity and Zoom Keys to change the setting for correcting
the feeding direction zoom ratio.
6.
Press the Clear/Stop Key to set the settings.
Setting Instructions
© If the scale on the copy is longer than the actual scale, decrease the setting value.
@ If the scale on the copy is shorter than the actual scale, increase the setting value.
"If the measurement does not fall within the specifications through one setting, try another setting.
Touch This a it
Measurement is Shorter,
Touch This Key
if
—1159D019AA
Measurement Is Longer.
7.
After the adjustments have been made, press the Clear/Stop Key two times to restore the copier to
the normal copy mode.
D-52
(8) Adjustment of the Reference Position of the Manual Bypass Table
@ Requirement
@ As shown in the illustration on the left, use a A4 test chart
ora sheet of 8-1/2" x 14" paper to draw a reference fine
20 mm from the left edge.
e@ Specification
.......ceeee eee 20 + 3.0mm
@ Important
This adjustment should be made after the "adjustment of zoom ratio in the crosswise direction'.
1.
Place the test chart on the reference position for the origi-
nal scale and close the Original Cover.
2.
Use the Manual Bypass Table to make a one copy using
" A4 or 8-1/2" x 14" paper at a 1:1 zoom ratio.
3.
Check if dimension A (from theedge up to the reference
line) on the copy is up to the specifications.
4.
Ifdimension A deviates from the specifications, loosen two
screws that secure the Manual Bypass Table and more the
table in the direction of the arrow as necessary.
Adjusting Instructions
© If dimension A deviates on the copy is shorter than 17
mm move the table to the rear of the copier.
® If dimension A deviates on the copy is longer than 23 mm
move the table to the front of the copier.
1159D14SAA
D-53
Advertisement
Table of Contents
