Functions Available From User Mode; User Mode Setting Procedure; User Mode Setting Details; Service Mode Function Tree - Minolta EP1030 Manual

1159SBS0400A
wij ~USER MODE
¢@ This mode is used to make various setting to the User's needs.
1159SBS0401A
4-1. Functions Available from the User Mode
Auto clear ON/OFF
1188SBS0402A,
4-2. User Mode Setting Procedure
<Setting Procedure>
1, Holding down the Exposure Control Key ©, turn ON the Power Switch. ("U1" appears on the
Display Panel.)
2. Press the Start Key to show the data set the selected function.
3. Using the Copy Quantity and Zoom Keys, change the set data.
4. Press the Clear/Stop Key to validate the new setting. (The function no. reappears.)
<Resetting Procedure>
® Press the Clear/Stop Key to quit the User Mode.
[User Mode]
1159SBS0403A
4-3. User Mode Setting Details
| Function No. | Setting (The defaultis iueMUincey .)
Ut <Auto clear ON/OFF>
Select whether or not to activate the auto clear (panel reset) function after the
lapse of a given period of time after a copy cycle has been completed or a key
on the control panel has been
operated.
Description Description
0 2 Disabled
0.5 Enabled : 30 sec.
Enabled : 1 min.
Enabled : 2 min.
Enabled : 3 min,
Enabled : 4 min.
ve
1158SBS0500A
ey SERVICE MODE
@ This mode is used by the Tech. Rep. to set, check, adjust, and/or program various service functions.
1159SBS0501A
5-1. Service Mode Function Tree :
dO : Warm-up time
d1 : Current JU Counter count display
d2 : Previous IU Counter count display
d3 : Display test
Display
¢1 : Marketing area
c2 : IU control mode
c3 : Auto power off disabling
c4:; ATDC detection level
c5 : Toner empty stop
c6 : Data clear
Tech. Rep.
Cholce
AO : Lens focal length correction
A1 ; Lens full size position correction
A2 : Feeding-direction zoom ratio correction
A3 : Full size registration adjustment
A4: Enlargement registration adjustment
AS5 : Reduction registration adjustment
A8 : SDH registration adjustment
AA : Leading edge erase width adjustment
Ab : ATDC Sensor adjustment data
AC : Max. Exposure Lamp voltage adjustment data
Adjust
F1 : Paper Passage Test
F2 :; Corona output
F3 : Exposure Lamp Voltage Adjustment
F5 : AE Sensor Automatic Adjustment
F8 : ATDC Sensor Automatic Adjustment
F9:1U Check, Optimum Exposure Adjustment
11598BS0502A
5-2. Entering the Service Mode
<Setting Procedura>
1. Perform the following steps to set the copier in to Service Mode.
<Leaving Service Mode>
® Press the Clear/Stop Key twice to quit the Service Mode.
S-7