Table of Contents
Advertisement
4.
Set to Service Mode.
5.
Toadjust the A8 SDH Registration, press the following keys In the indicated sequenca: Copy Quantity
and Zoom Key @ two times; the Start Key one time and the Copy Quantity and Zoom Key O six times.
1159D031AA
1159D0S2AA
Press the Keys in order of [1], [2], [3],
"A8" will appear in the Display Panel.
(4), (5), [6], (7), [8], and [9].
|
|
6.
Press the Start Key to and use the Copy Quantity and Zoom Keys to change the settings forthe SDH
CY
Registration Adjustment.
7.
Press the Clear/Stop Key to set the settings.
|
Setting instructions
© If dimention A on the copy is longer than 22 mm, increase the setting value.
© !f dimentlon A on the copy is Shorter than 18.5 mm, decrease the setting value.
* If the measurement does not fall within the specifications through one setting, try another setting.
Touch This Key It
Measurement is Longer.
Touch This Key #
—1189D024AA
Measurement is Shorter.
D-66
(15) Adjustment of SDH Center Alignment (EP1030F/EP1031F Only)
Requirement
1159D149AA
1159D15S6AA
®@ As shown in the illustration to the left, usa a Test Chart
and adjust so that deviation of the lengths of Width A and
Width B on the copy will be within the Specification
shown below.
© Specification
... B Width — A Width = + 1.0mm
NOTE
| Width A plus B must be 120 mm or more.
|
1.
Place the test chart in the SDH.
2.
Make a one copy using A4 or 8-1/2" x 14" paper ata 1:1
zoom ratio.
3.
Check that the reference line for
the Test Chart on the copy
is within the standards.
4.
If the reference position is outside the standards, loosen
the two mounting screws on the left side of the SDH and
move it in the direction shown by the arrow in the illustra-
tion.
Adjusting Instructions
If the deviation of the length of Width A and Width B on the
Chart is
+ .....,. Move the SDH to the right.
dikes a Move the SDH to the left.
D-67
Advertisement
Table of Contents
