Table of Contents
Advertisement
NOTE
When reassembling the Optical Section Cooling Duct,
make sure the Rear Wire is retained as shown in the il-
9.
Removethe Hamess forthe Scanner Drive Motor from the
|
Locking Edge Cover and remove it from the Cord Clamp.
10. Remove two screws and the Scanner Drive Motor M4.
lustration.
1159D069AA
|
|
|
(9) Removal of the Scanner Drive Cable
14, Remove two screws and the Optical Cover.
|
1.
Swing down the Front Door.
Release and swing up the Upper Half of the copier.
Remove the Imaging Unit from the copier.
Remove the Upper Left Cover, Upper Front Left Cover and Rear Cover.
Swing down and lock the Upper Half of the copier.
Remove the Original Scale and Original Glass.
Remove the SDH Glass. (EP 1030F/EP1031F Only)
1158D073AA
Remove the Upper Right Cover.
PNOarpon
9.
Remove the two screws and one connector and the Con-
trol Panel.
10. Remove the one screw and the Upper Unit Release Lever,
11. Remove the three screws and the Lower Panel Cover.
15. Unhook each of the two springs at the front and rear and
remove the cable.
|
1159D070AA
12. Move the Scanner tothe canter and remove the one screw
and the front and rear Scanner Mounting Brackets.
16. Snap off the one E-ring from the Pulley Shaft.
17. Remove the one screw from the Drive Belt Pulley.
18. Remove each screw from the front and rear Cable Drive
Pulleys.
1158D075AC
19. Remove the Pulley Shaft.
13. Remove the two screws and the Optical Section Cooling
:
20. Remove the Cable Drive Pulley.
Duct.
1%68D076AC
Advertisement
Table of Contents
