Table of Contents
Advertisement
(3) Adjustment of Exposure Level in the Auto Exposure Mode
(4) ATDC Adjustment
@ Important
|
@ Important
:
@ ATDC adjustment is not necessary when a new IU Is used. (Set the Starter and ATDC adjustment will be
@ When making adjustments, the exposure position on the Control! Panel must be set to Auto.
|
automatically entered when the power is turned on.)
® For the adjustment, place about five blank sheets of A4 or 8-1/2" x 14" paper one on top of the
© Always perform ATDC adjustment when a new Starter has been set with a existing IU.
other on the Original Glass and lower the Original Cover.
¢ After this adjustment, be sure to check the "Adjustment of optimum exposure setting in the Manual
Exposure mode".
1.
Set the Starter and close the Front Door.
1.
Confirm that the exposure position on the Control Panel is set to Auto. Stack five blank sheets of A4
or 8-1/2" x 14" paper on top of each other on the Original Glass and close the Original Cover.
1
re
-
H
rN
d oo000 D
2.
Setto Service Mode.
1159D012AA
1159D195AA
'
Key © four times.
1159D136AA
2.
Set to Service Mode.
!
3. - Toadjust the F5 AE Sensor Automatic Adjustment, press the following keys in the indicated sequence:
Copy Quantity and Zoom Key © three times; the Start Key one time and the Copy Quantity and Zoom
-
Key
three times.
|
4.
Press the Start Kay to perform adjustment of the Auto Exposure. (Approximately 15 Seconds)
Press the Keys in order of [1], [2], [3],
"FS" will appear in the Display Panel.
(4], [5}, [6] and [7].
5.
After the adjustments have been made, press the Clear/Stop Key two times to restore the copier to
the normal copy mode.
[oylontey(ey
1TB9DOIGAA
1159D016AA
Press the Keys in order of [1], [2], [3],
"F8" will appear in the Display Panel.
(4), {5], and [6].
:
4.
Press the Start Key to perfonn adjustment of the ATDC.
5. _ After the adjustments have been mada, press the Glear/Stop Key two times to restore the copier to
118900144
~
the normal copy mode.
.W169D013AA
D-46
|
D-47
Advertisement
Table of Contents
