Table of Contents
Advertisement
1158SBS000EA
1189SBS0600A
fag
FUNCTION SETTING REQUIREMENTS AT REPLACEMENT OF PART
¢ If a part is raplaced as part of troubleshooting and other service jobs, some parts require that a Test
operation be run and data values reentered and/or cleared.
AE
PWB-A
Sensor
(*5)
F8 (ATDC)
Cleaning of CP-
related Counter (*1)
O: Required
©
Make the adjustments in numerical order.
*1: Clear the CP-related counter, select "2: CP-related counter" in the Data Clear mode (c6) of Tech.
Rep. Chaice moda, then switch the power offfon.
*2: When replacing the IU, F8 and CP-related counter are automatically cleared.
*3: Including the replacement of the ATDC Sensor.
*4: Including the Cleaning of Lamp Regulator and optical system.
*5: When replacing PWB-A, if the EEPROM (!C3A) from the old PWB-A is installed on the new PWB-A,
these adjustments are not necessary.
*6: Input the F3 setting on the factory label inside the front door.
*7: Input the Ab setting on the factory label inside the front door.
MINOUA
MINOLTA CO., LTD.
S-18
Advertisement
Table of Contents
