Advertisement
Slot#2
10:48
Figure 12.8-11 Setting menu for Slot #2 module
Figure 12.8-12 shows the Output Circuit configuration of BO01 at IO#2 (Slot#2).
The procedure for operation is similar to the operation of the binary input circuit.
(Refer to Figure 12.8-7 to Figure 12.8-9)
SLOT2-BO01-SET
10:48
Figure 12.8-12 Setting menu after selecting "SLOT2-BO01-SET"
The user can configure the required settings for the simulation test of the binary
output circuit.
•
Output signal for simulation test is ON
ON:
•
Output signal for simulation test is OFF
OFF:
•
Actual inputs are applied.
Normal:
F. Signal Control screen: The user is able to forcibly control generation/non-
generation of the transmission signal during the point-to-point test. For
example, if the user wishes to forcibly control with FSC01 signal, the user can
select FSC01-SET screen, as shown in Figure 12.8-13.
F. Signal Control
10:48
33
Figure 12.8-13 Setting menu for F. Signal Control
The user can then select the control style on the screen shown in Figure 12.8-14.
1/19
BO2F OP
+
SLOT2-BO01-SET
+
Normal
SLOT2-BO02-SET
+
Normal
SLOT2-BO02-SET
+
1/3
Normal
Off
On
1/
FSC OP
FSC01-SET
Normal
FSC02-SET
Normal
FSC03-SET
Normal
FSC32-SET
Normal
- 1028 -
+
+
+
+
+
6F2T0207 (0.01)
GRE200 (5,6)
Advertisement
