Advertisement
Signal name and number
(v)
Note: The user should note the following descriptions shown in the column "M/O" for
each table:
"O" indicates that the signal is provided for optional use.
"M" indicates that the user should map/set/configure the signal; otherwise, the
"N/A" indicates that the user cannot change the state of the signal.
Table 4.3-4 PLC connection point #3 (Input points on select condition logic)
Signal Number
Signal Name
543081 801900ED50
PWRQ_CTRL_RIGHT
Table 4.3-5 Mapping points for the command reception of HHD and VAR resetting
Signal Number
Signal Name
543081 7019016D08
PWRQ_HHD_RSTREQ
543081 7019026D08
PWRQ_VAR_RSTREQ
Table 4.3-6 Mapping points for the output signals of HHD and VAR resetting
Signal Number
Signal Name
543081 3119001005
PWRQTY_QUALITY
543081 3019011008
HHD_ORCAT
543081 6A19011009
HHD_ORIDENT
543081 9019011006
HHD_TIMESTAMP
543081 0019011D90
HHD_RST_STSELD
543081 3019021008
VAR_ORCAT
543081 6A19021009
VAR_ORIDENT
543081 9019021006
VAR_TIMESTAMP
543081 0019021D90
VARIATION_RST_STSELD
Signal Number
Signal Name
4A0001 8300001B6F
GEN. TRIP
5A0101 3100001F43
SERI_ERR
Table 4.3-8 PLC monitoring points(for control right at HHD and VAR resetting)
Signal Number
Signal Name
543081 8519011E45
HHD_SE_RCV
543081 8519021E45
VAR_SE_RCV
user may experience an operational failure if the default settings are
used.
Description
Control right from PLC (Common)
Table 4.3-7 Input signals for condition logic
Description
General trip
Serious Error detected
Description
Receive selection/operation command for HHD reset
Receive selection/operation command for VAR reset
- 566 -
Description
Reset request for HHD
Reset request for voltage variation
Description
Quality for PWRQTY(common)
Origin(orCat) for HHD
Origin(orIdent) for HHD
Timestamp for HHD
Selected signal(stSeld) for HHD
Origin(orCat) for VAR reset.
Origin(orIdent) for VAR reset.
Timestamp for voltage VAR reset.
Selected signal(stSeld) for VAR
6F2T0207 (0.01)
M/O
M
M/O
M
M
M/O
M
M
M
M
O
M
M
M
O
M/O
N/A
N/A
GRE200 (5,6)
Advertisement
