XSCF> showuser -l
User Name:
UID:
Status:
Minimum:
Maximum:
Warning:
Inactive:
Last Change:
Password Expires:
Password Inactive:
Account Expires:
Privileges:
Note - Considering maintenance work, be sure to prepare a field engineer (FE) user account
that has the fieldeng user privilege.
We recommend that the system administrator create accounts with the platadm, useradm,
auditadm, and fieldeng user privileges.
6.3
Configuring the Telnet/SSH Service
To use the XSCF shell terminal and the control domain console of the specified
physical partition, use Telnet or SSH.
SSH and Telnet can be concurrently enabled. However, a Telnet connection is not
based on a secure connection protocol. We recommend disabling Telnet when SSH is
enabled.
6.3.1
Configuring the Telnet service
This section describes how to configure the Telnet service.
1.
Execute the showtelnet command to display the Telnet setting.
The following example displays the Telnet service setting. The factory default
setting is "disabled".
XSCF> showtelnet
Telnet status: disabled
2.
Execute the settelnet command to configure the Telnet service.
The following example specifies that the Telnet service be enabled.
Fujitsu M10-1/SPARC M10-1 Installation Guide ・ March 2019
94
jsmith
359
Enabled
0
60
15
-1
May 22, 2013
Jul 21, 2013
Never
Never
useradm
platadm