Table of Contents
Advertisement
7 Installing LAN
THIS CHAPTER DESCRIBES HOW TO INSTALL THE LAN INTERFACE
7.1 Overview
The emulator MB2198-01 is equipped with a local area network adapter that can be used to
program and debug a device over a network connection. No additional hardware connection
except the LAN connection itself is required for this purpose
Using the Fujitsu LAN-remote controlled debug facility,
•
You can control the emulator from different locations without having to move your
hardware installation from one place to another.
•
Program download will be more than 6 times faster than with RS232C
7.2 Configuring the LAN Adapter
1
Refer to the LAN Installation Manual coming with the LAN Adapter.
This Application Note will give only some additional information.
2
Connect emulator and PC by the serial RS232-Port (or USB-Port)
3
Start the „LAN Address" Program in the Softune Workbench Folder
4
Click on Communication to define the serial RS232 Port where the emulator is
connected to or use USB connection.
5
Read current status from the emulator
6
Set the unique IP address given from your network manager. This is a very important
point, every IP-address within a network has to be unique.
7
Check the Port address: must be 5001
8
Make settings valid by „Set", and reset the emulator when prompted
9
Close Program „LAN Address"
MCU-AN-300217-E-V10
MB2198 – Getting Started
Chapter 7 Installing LAN
- 26 -
© Fujitsu Microelectronics Europe GmbH
Advertisement
Table of Contents
