Logging In To The Xscf - Fujitsu ORACLE M10-1 Installation Manual

Figure 5-2 Rear of the SPARC M10-1
5.3

Logging In to the XSCF

This section describes the procedure for logging in to the XSCF by using the default
XSCF user account.
Log in to the XSCF by using the default user account and authentication method until
a user account appropriate to the user environment is registered for you. The default
user privileges are useradm and platadm.
Remarks - platadm is mainly used to manage the whole system. useradm is mainly used to
manage user accounts. For details on the user privilege types and the privileges, see
6-3.
1.
After the system management terminal displays "SCF_READY", press the
[Enter] key.
2.
After the login prompt appears, enter "default" for the login name.
login: default
3.
After a message prompting operation of the mode switch appears, operate
the mode switch on the operation panel as follows.
a. Switch the mode switch on the operation panel to the Locked position, and
Change the panel mode switch to Locked and press return... Omitted
b. Leave the switch in that position for at least 5 seconds.
Leave it in that position for at least 5 seconds.
c. Return the mode switch to the Service position, and press the RETURN key.
press the RETURN key.
Chapter 5 Performing an Initial System Diagnosis
Table
81