Installation
Connector D - Drive 4
3.7.2.2
Connecting SAS cables
Ê Shut down the server.
Ê You can assign up to four SAS ports on your backup subsystem (see
"Ports on a SAS/SATA backup subsystem" on page
that Channels A to D are assigned in the correct order.
For the factory-provided SAS configuration, the connectors on the rear side and
the drives on the front are connected 1:1.
Connector D - Drive 4
I
3.7.2.3
Connecting USB cables
Ê You can assign up to four USB ports on your backup subsystem (see
"Ports on an USB backup subsystem" on page
For the factory-provided USB configuration, the connectors on the rear side and
the drives on the front are connected 1:1.
Connector A - Drive 1
Connector B - Drive 2
Connector C - Drive 3
Connector D - Drive 4
I
The change of these settings (drive / connector correlation )should only
be performed by our service team or by a technical specialists
FibreCAT TXF
Connecting the backup subsystem
Operating Manual
34). You must ensure
34).
figure
figure
37