Setting An Ethernet (Xscf-Lan) Ip Address; Setting The Routing - Fujitsu ORACLE M10-1 Installation Manual

XSCF> sethostname -d example.com
6.5.2

Setting an Ethernet (XSCF-LAN) IP address

The XSCF-LAN is a LAN established for user access to the XSCF. Two XSCF-LAN
ports can be used, depending on the network configuration.
For the SPARC M10-1, set either or both of the following IP addresses:
- XSCF-LAN#0 of BB#00
- XSCF-LAN#1 of BB#00
Figure 6-1 Example of XSCF-LAN settings
192.168.1.x (1)
Remarks - Configure the XSCF-LAN#0 and XSCF-LAN#1 ports such that they are on
different subnets. (See (1) in
1.
Execute the setnetwork command with network interface information specified.
The following example sets the IP addresses and net masks for XSCF-LAN#0 and
XSCF-LAN#1 of BB#00 to enable them.
XSCF> setnetwork bb#00-lan#0 -m 255.255.255.0 192.168.1.x
XSCF> setnetwork bb#00-lan#1 -m 255.255.255.0 192.168.2.a
6.5.3

Setting the routing

1.
Execute the showroute command to display the routing environment.
XSCF> showroute -a
Destination
Destination
BB#00
Master XSCF
LAN#0 LAN#1
192.168.2.a (1)
Figure
Gateway
Gateway
6-1.)
Netmask
Netmask
Chapter 6 Making the Initial System Settings
Flags Interface
Interface
99