Saving Xscf Setting Information - Fujitsu ORACLE M10-1 Installation Manual

The following example shows that the file named ldm_set1 is the save destination.
primary# ldm add-spconfig ldm_set1
4.
Execute the ldm list-spconfig command, and confirm that the configuration
information was saved correctly.
primary# ldm list-spconfig
6.14.2

Saving XSCF setting information

Save XSCF setting information.
This section describes procedures for saving XSCF setting information via a network
and saving the setting information to a USB device.
For details on how to restore the setting information, see "10.10 Saving/Restoring
XSCF Setting Information" in the Fujitsu SPARC M12 and Fujitsu M10/SPARC M10
System Operation and Administration Guide.
- Specifying the target directory and saving the setting information via a
network
1.
Specify the target directory and the output file name, and execute the
dumpconfig command.
XSCF> dumpconfig ftp://server/backup/backup-file.txt
2.
Confirm the identification information at the beginning of the saved
configuration file when the data transfer has completed.
- Saving the setting information to a USB device on the master XSCF
1.
Connect a USB device to a USB port on the XSCF unit panel (rear panel) of the
master XSCF.
2.
Specify the name of the output file for the local USB device on the XSCF, and
execute the dumpconfig command.
XSCF> dumpconfig file:///media/usb_msd/backup-file.txt
3.
After the data transfer has completed, remove the USB device from the USB
port.
4.
Confirm the identification information at the beginning of the saved
configuration file.
Fujitsu M10-1/SPARC M10-1 Installation Guide ･ March 2019
114