Polling Reserve Report; Polling Result Report - Ricoh 185 Operating Instructions Manual

B
Enter the "Polling RX" function
number with the number keys.
Note
If the appropriate display is not
shown, press [↑ ↑ ↑ ↑ Prev.] or [↓ ↓ ↓ ↓ Next].
C
Depending which method you
are using, choose one of the fol-
lowing procedures:
Default ID Polling Reception
A Press the 0 0 0 0 or 1 1 1 1 key to select
the Default ID and press [OK].
ID Override Polling Reception
A Press the 0 0 0 0 or 1 1 1 1 key to select
the Override ID and press [OK].
B Enter a polling ID (4 charac-
ters) with the number keys and
the letter (A–F).
Note
If you make a mistake, press
the {Clear/Stop} key and try
again.
0000 and FFFF is not avail-
able.
D
Press [OK].
The Transmission Mode menu is
shown. A check mark is added to
Polling Reception.
Note
To cancel Polling Reception,
press [Cancel]. The Transmis-
sion Mode menu is shown.
E
Press [Exit].
The following display is shown.
Note
"Polling RX" is displayed.
F
Dial and press the { { { { Start} } } } key.

Polling Reserve Report

This report is printed after Polling Re-
ception has been set up.
Note
By default this report is turned off.
Turn it on with the User Parame-
ters. ⇒ P.184 "Changing the User
Parameters"

Polling Result Report

This report is printed after a Polling
Reception has been completed and
shows the result of the Polling Recep-
tion.
POLLING RECEPTION
4
85