Ricoh 185 Operating Instructions Manual page 30

Getting Started
• When you set an original on the exposure glass, it is detected as the follow-
ing table. If you select Irregular Scan Area, lengths up to 17" are possible.
width
1
- - Maximum Scan Area
- -
Memory Transmission/Immediate Transmission
• From the Document Feeder (ADF): 11" × 47" / 297 × 1,200mm (W × L)
• From the exposure glass:11" × 17" / 297 × 432mm (W × L)
Note
The maximum scan area for Immdediate Transmission depends on the reso-
lution and installed optional Expansion Memory.
If the Machine Cannot Detect the Size of Your Original
If the machine cannot detect the original size, the following display is shown:
If this happens, carry out the following steps.
A
Remove the original and replace it on the exposure glass. Press the { { { { Start} } } }
key to scan the original again. If the machine still cannot detect the original
size, the following display is shown:
B
Press the 0 0 0 0 and 1 1 1 1 keys to switch the scan size and press the { { { { Start} } } } key
again.
16
Length
∼ "9.60
"9.60 ∼ "10.60 "8 × "10K
"10.60 ∼
∼ "12.50 "12.50 ∼ "13.50
"8.5 × "13
LTL
not detected
LTK not detected
"13.50 ∼
"8.5 × "14L
"10 × "14L
DLTL