Table of Contents
Advertisement
CAUTION:
Take care not to damage the system identification button while placing the system board into the
chassis.
2. Holding the system board holder and plunger, lower the system board at a tilted angle into the system.
3. Slide the system board towards the rear of the chassis until the connectors are firmly seated in the slots.
Figure 196. Installing the system board
Next steps
1. Replace the following components:
a.
Trusted Platform Module (TPM)
NOTE:
The TPM Module must be replaced only while installing new system board.
b.
Internal USB card (if removed)
c.
OCP card (if removed)
d.
Processor and heat sink module
e.
Memory modules
f.
Expansion card risers
g.
Serial COM port (if removed)
h.
BOSS-N1 module
i.
Cooling fan cage assembly
j.
Air shroud
k.
Power supply units (PSU)
2. Reconnect all cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Ensure that you perform the following steps:
a. Use the Easy Restore feature to restore the Service Tag. See the
feature
section.
b. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the
update the Service Tag
c. Update the BIOS and iDRAC versions.
236
Installing and removing system components
by using System Setup section.
Restoring the system by using the Easy Restore
Manually
Advertisement
Table of Contents
