Table of Contents
Advertisement
Figure 138. Removing the BOSS-N1 module
4. Align the blank with the BOSS-N1 module slot and push it into the bay until it clicks into place.
NOTE:
Blanks must be installed in empty slots to maintain FCC certification of the system. The blanks also keep dust
and dirt out of the system and aid in proper cooling and airflow inside the system.
Figure 139. Installing the BOSS-N1 module blank
5. Using a Phillips #2 screwdriver, tighten the screw that secures the BOSS-N1 module blank to the system.
Next steps
Replace the BOSS-N1
module.
Installing the BOSS-N1 module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3.
Remove the air
shroud.
4. If installed,
remove the front
Steps
1. Using a Phillips #2 screwdriver, remove the screw that secures the BOSS-N1 module blank from the system.
Safety
instructions.
Before working inside your system
bezel.
.
Installing and removing system components
187
Advertisement
Table of Contents
