Table of Contents
Advertisement
2. Slide out the BOSS-N1 module blank from the system using a flat head screwdriver.
Figure 140. Removing the BOSS-N1 module blank
3. Align the BOSS-N1 module to the BOSS-N1 slot on the chassis and push it into the slot.
4. Using a Phillips #2 screwdriver, secure the BOSS-N1 module to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 141. Installing the BOSS-N1 module
5. Connect the cables to the system board connectors.
NOTE:
Route the cables properly to prevent them from being pinched or crimped.
Next steps
1. If removed,
install the front
2.
Install the air
shroud.
3. Follow the procedure that is listed in
Removing the BOSS-N1 card carrier
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
188
Installing and removing system components
bezel.
After working inside your
Safety
instructions.
Before working inside your system
system.
.
Advertisement
Table of Contents
