Table of Contents
Advertisement
Figure 110. Installing the 3.5-inch drive backplane
Next steps
1.
Install the
drives.
2. Connect the drive backplane cables to the connector on the backplane.
3.
Install the cooling fan assembly.
4.
Install the front PERC
5. Follow the procedure listed in
Removing the 2.5-inch drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, remove the drives from the system before removing
the backplane.
CAUTION:
Note the number of each drive and temporarily label them before you remove the drive so that you
can reinstall them in the same location.
NOTE:
The procedure to remove the backplane is similar for all backplane configurations.
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3.
Remove the cooling fan cage.
4.
Remove the drives.
5.
Remove the front PERC module
6. Disconnect the drive backplane cables from the connectors on the backplane.
Steps
1. Pull the blue release stand-off to disengage the drive backplane from the hooks on the system.
2. Lift and pull the drive backplane out of the system.
162
Installing and removing system components
module.
After working inside your
Safety
instructions.
Before working inside your system
system.
.
Advertisement
Table of Contents
