Table of Contents
Advertisement
Figure 134. Installing the front IO module
3. Connect the power and data cables from the front IO module to the system board.
Next steps
1. Connect the power cable and the data cable to the front IO module.
NOTE:
Route the cables properly to prevent them from being pinched or crimped.
2.
Install the front
bezel.
3.
Install the air
shroud.
4. Follow the procedure that is listed in
System memory
System memory guidelines
The PowerEdge T560 system supports DDR5 registered DIMMs (RDIMMs).
Your system memory is organized into eight channels per processor (one memory socket per channel), 8 memory sockets per
processor and 16 memory sockets per system.
182
Installing and removing system components
After working inside your
system.
Advertisement
Table of Contents
