Table of Contents
Advertisement
Figure 112. Installing the 2.5-inch drive backplane
Next steps
1.
Install the
drives.
2. Connect the drive backplane cables to the connector on the backplane.
3.
Install the cooling fan cage.
4.
Install the front PERC
5. Follow the procedure listed in
Drive bays
Removing the drive bay blank
Prerequisites
1. Follow the safety guidelines listed in the
2.
Remove the system
cover.
3. If installed,
remove the front bezel.
Steps
1. Using a Phillips #2 screwdriver, remove the screws that secure the drive bay blank to the system.
2. Using a flat head screwdriver, remove the drive bay blank.
NOTE:
The procedure to remove the drive bay blanks are similar.
164
Installing and removing system components
module.
After working inside your
Safety
system.
instructions.
Advertisement
Table of Contents
