Dell PowerEdge T560 Installation And Service Manual page 157

Figure 104. Installing a drive into the drive carrier
Next steps
1. Install the drive carrier.
Removing the drive from the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the
2. Remove the drive carrier..
Steps
1. Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE: If the drive carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to
remove the drive.
2. Lift the drive out of the drive carrier.
Safety instructions.
Installing and removing system components 157