Table of Contents
Advertisement
Figure 103. Installing a drive carrier
Next steps
install the front
bezel.
Installing the drive into the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the
2.
Remove the drive
blank.
Steps
1. Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
2. Align the screw holes on the drive with the screws holes on the drive carrier.
3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with the screws.
NOTE:
When installing a drive into the drive carrier, ensure that the screws are torqued to 4 lbf-in.
NOTE:
If the drive carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to
install the drive.
156
Installing and removing system components
Safety
instructions.
Advertisement
Table of Contents
