Replacement Of The Drive Belt - Stiga MP 84/98 Workshop Manual

WORKSHOP MANUAL
MP 84/98 - MP 84/98 Hy
General informations
­­­
Related topics
[ 4.3] Drive belt adjustment
[ 5.3] Removing the ejection conveyor
[ 5.5] Removal of the engine
[ 5.7] Removing the cutting deck
[ 5.8] Removing the ejection conveyor
[ 6.9] Replacement of the lifting cable
[ 8.2] Belts assembly
Tightening torques
7 Drive pulley fastening nut ............... 25 ÷ 30 Nm
9 Nut for pulley of the guide pulley .... 25 ÷ 30 Nm
11 Nuts for small wheels ................... 25 ÷ 30 Nm
Map of functional units

REPLACEMENT OF THE DRIVE BELT

Remove the rear of the conveyor.
Removing the cutting deck.
Remove the wire of the deck lifting lever.
Remove the engine pulley and the clutch
Engage the parking brake to slacken off the belt and
obtain greater operating convenience.
mechanical drive models:
Loosen the two side screws (1) and (2) and move
the two belt guides (3) and (4).
1
6 5
3
Hold the two parts of the belt (5) to release it from the
pulley (6).
8
5
CHAPTER
6.4
10 9
2
Loosen the nut (7) for the drive pulley (8) to the point
where the passage of the belt is allowed (5).
Unscrew the nut (9) and take off the pulley of the guide
pulley (10).
4
Unscrew the nuts (11), remove the two small wheels
(12) and remove the belt (5).
REVISION FROM ... PAGE
1 2018 1 of 1
8
7
11
12
5