Stiga MP 84/98 Workshop Manual page 43

WORKSHOP MANUAL
MP 84/98 - MP 84/98 Hy
Detach the fuel line pipe, taking care not to spill
fuel.
Identify and undo all the screws that fasten the
engine to the chassis, then carefully lift and remove
the engine using equipment suitable for the weight of
the engine (about 35-45 kg) and the designated lifting
points to guarantee safe working conditions.
NOTE Some engines are held with screws of differ­
ent length and in different positions, so it is best to
label them so that no errors are made on reassembly.
REMOVAL OF THE ENGINE
For reassembly follow the operations described a bo-
ve in reverse.
If the spacer (7) is installed, it must be fitted with the
counter-sinking hole facing the engine.
Ensure that the pin (9) is inserted in the groove in the
clutch (2) and remember to replace the spring (4).
7
4
2
2
CHAPTER REVISION
5.5 2
9
2
8
Fully tighten the engine and pulley fixing screws to the
prescribed values.
Remember to fit the clamps back on the fuel
pipe and check that it does not leak.
Carefully restore all electric and earth contacts and al-
ways refit the exhaust guard (8).
Reattach the accelerator cable and ...
Adjust the «MINIMUM» position.
Refit the front hood.
FROM ... PAGE
2018 2 of 2