Stiga MP 84/98 Workshop Manual page 60

WORKSHOP MANUAL
MP 84/98 - MP 84/98 Hy
The second bearing still in place must be removed by
hitting it from the inside of the flange using a 12 ÷ 15
mm diameter round bar (17).
17
9
On reassembling, first put the shaft into the hole of
the lower bearing and insert this into the support. Fit
on the upper bearing and, using the special bush (18)
which works on the inner ring, hit it squarely with a
mallet until the bearing is fully driven home.
18
9
REPLACEMENT OF THE SUPPORTS
AND SHAFTS OF THE BLADES
IMPORTANT The right and left shafts seem to be the
same, but can be differentiated as follows:
– right shaft: red paint on the pulley side;
– left shaft: green paint on the pulley side.
Before refitting the support assembly, check that the­
se positions are correct.
Fit the flange supports onto the deck, fully tighte ning
the nuts (10).
CHAPTER REVISION FROM ...
6.7 1 2018
PAGE
3 of 3