WORKSHOP MANUAL
MP 84/98 - MP 84/98 Hy
General informations
Related topics
---
Map of functional units
REPLACEMENT OF THE ACCELERATOR AND
ADJUSTMENT OF THE CARBURETTOR
2
3
1
Unscrew the screw (1), take off the knob (2) and un do
the two screws (3) which hold the accelerator on the
dashboard.
From the motor side, loosen the terminal screw (4),
disconnect the wire (6) terminal (5) from the slider (7)
and remove the accelerator with the wire.
CHAPTER
REVISION
FROM ...
6.8
1
2018
7
5
4
To assemble, put the accelerator lever in «MIN» and
connect the wire (6) terminal (5) to the slider (7).
Move the slider (7) to the specific «MIN» position for
each type of motor and indicated in the relevant in-
struction booklet. Then secure the wire (6) to the ter-
minal (4).
PAGE
1 of 1
6