Replacement Of The Drive Belt - Stiga T 102 Series Workshop Manual

WORKSHOP MANUAL
T...102/122 - TC...102/122
Validity
General informations
­­­
Related topics
[ 4.3] Drive belt adjustment
[ 5.3] Removal of the collector channel
[ 5.5] Removal of the engine
[ 8.2] Belts assembly
Tightening torques
3 - 4 Nuts for pulleys ........................... 25 ÷ 30 Nm
7 Nuts for small wheels ...................... 25 ÷ 30 Nm
Map of functional units

REPLACEMENT OF THE DRIVE BELT

Dismantle the engine pulley
Remove the collector channel.
It is advisable to slacken the transmission belt to work
on the parts involved more easily. This is done by
slackening the stretcher.
Dismantle the drive pulley (1) and the stretcher pulley
(2), fixed by nuts (3) and (4) respectively, and slacken
the belt guide (5) enough to free the belt (6).
2
6
4
1
3
Slacken off the fixing nuts (7) of both small wheels
(8) and remove the pin (9) from the brake rod to allow
passage of the belt.
CHAPTER REVISION
6.4
On reassembly ensure the exact positioning of the belt
(6) with respect to the pulleys, the small side wheels
and the containment guides [see 8.2.4], with special
reference to its passage through the belt guide fork
(5).
Always refit the dust covers (10) of the wheels (8).
When assembly is completed ...
5
Refit the engine pulley.
Adjust the drive engagement.
Refit the collector channel.
Tighten the spring of the stretcher.
10
8
7
FROM ... PAGE
0 2018 1 of 1
9