Stiga MP 84/98 Workshop Manual page 53

WORKSHOP MANUAL
MP 84/98 - MP 84/98 Hy
5
7 6
Reassemble the ring gear matching the two
referen ces (⇒ ◁), punched on the ring gear (13) with
the pinion (5) in the drive direction.
Reassemble the nuts (8) and (9), tightening them to
load the cup springs (10) and (11) as much as need
to ensure steering manageability, without creating ex-
cessive play.
Refit the steering tie-rod (7) and tighten the nut (6) to
the prescribed value.
DISMANTLING OF THE STEERING
Unhook the spring (21) and lift the steering column
(22) just enough to be able to draw out the pinion (23),
13 9
taking care not to take out the pin (24).
8
24
23
Use a universal socket wrench to unscrew the two
screws (25) that fix the plate (26) and remove the
spherical lower bush (27).
On reassembly ensure that the bush (27) is fitted with
the protuberant part upwards.
25
26
COMPONENTS
B) Lower bush replacement
22
21
25
27
CHAPTER REVISION FROM ...
6.3 0 2018
Refit the plate (26) without tightening the screws (25).
Correctly reposition the pin (24) in the pinion hou sing
(23) and align the pinion to the ring gear.
Insert the end of the steering column (22) in the hole
in the spherical bush (27); fully tighten the screws (25)
after having checked the correct alignment and regu-
lar rotation of the steering column.
Check the steering geometry
PAGE
2 of 2