Stiga MP 84/98 Workshop Manual page 69

WORKSHOP MANUAL
MP 84/98 - MP 84/98 Hy
General informations
­­­
Related topics
---
Map of functional units
SAFETY MICROSWITCHES OPERATION
CHECK
This check is done by disconnecting connector CN1
and using the tester in Ohmmeter mode.
This o peration must be performed without the opera-
tor a board, making contact with the ferrules on the
contacts of the wiring connector (1) and must give
these results:
N° Contacts Tester reading and condition
GRASS-CATCHER ATTACHED MICROSWITCH
10 - 6 ∞ (without g.catc.) O (with g.catcher)
SEAT MICROSWITCH
10 - 14 ∞ (absent)
PARKING MICROSWITCH
10 - 17 O (free)
BLADE SWITCH
10 - 16 ∞ (engaged)
"IN NEUTRAL" SIGNAL
10 - 7 ∞ (drive)
GRASS-CATCHER FULL MICROSWITCH
13 - Earth O (full)
REVERSE GEAR MICROSWITCH
10 - 15 ∞ (Pressed)
REVERSE CONSENT BUTTON
8 - 9 O (Pressed)
STARTER UNIT
+ Battery - 11 ∞ (OFF) O (ON)
+ Battery - 12 ∞ (OFF) ∞ (ON)
CHAPTER
7.3
ENGINE STOP
O (seated)
This operation must be done by keeping the connec-
tor (1) attached and should give this result:
∞ (engaged)
O (disengaged)
O (neutral)
∞ (empty)
1
O (Released)
∞ (Released)
N° Contacts
O (START)
3 - Earth
O (START)
REVISION FROM ... PAGE
1 2018 1 of 1
11 1
12 2
11
13 3
12
14 4 1 13
2 14
15 5
15
3
4
16
16 6
5
17
17 7
6 18
7
19
18 8
8
20
9
19 9
1
10
20 10
3
Tester reading and condition
O (Always)