WORKSHOP MANUAL
TC 108 SD - TC 118 SD
General informations
Related topics
[
4.3]
Drive belt adjustment
Removal of the wheel cover
[
5.2]
[
5.4]
Removal of the engine (
[
5.4a]
Removal of the engine (
[
5.7]
Removal the rear tank (if present)
[
8.2]
Belts assembly
Tightening torques
3-4 Nust for pulleys ............................. 25 ÷ 30 Nm
Map of functional units
REPLACEMENT OF THE DRIVE BELT
Dismount the engine pulley and the clutch.
Remove the rear part of the wheel cover
Remove the rear tank (if present)
TC 108 SD)
TC 118 SD)
Working from the rear section, grasp the two branch-
es of the belt (1), pulling it just enough to free it from
the pulley throat (2), overcoming the resistance of the
idler pulley spring.
Loosen the nuts (3) and (4) that fasten in place re-
spectively the return pulley and the tensioner (6),
enough to allow the belt to pass (1)
2
1
6
1
4
5
3
CHAPTER
REVISION
FROM ...
6.4
0
2018
At this point the belt (1) is completely free and can be
extracted.
During reassembly operations, make sure the belt (1)
is positioned accurately in relation to the pulleys and
the containment guides.
When assembly is completed,
Replace the engine pulley and the clutch.
Adjust the drive belt.
Replace the rear tank (if present)
Replace the rear part of the wheel cover.
PAGE
1 of 1