WORKSHOP MANUAL
MP 84/98 - MP 84/98 Hy
General informations
The removal of the front part of the conveyor
makes the small side wheels and the transmis
sion belt accessible.
The removal of the conveyor's rear part is neces
sary to disassemble the cutting deck and in case
the rear plate is removed.
Related topics
[
5.7]
Removal of the cutting deck
[
6.1]
Removal of the wheels
Tightening torques
11 Screws for front discharge conveyor 8 - 10 Nm
Map of functional units
REMOVAL OF THE DISCHARGE CONVEYOR
A) Rear
The conveyor (1) is connected to the rear plate (2) by
two plastic clamps (3), removable with the help of a
screwdriver.
On assembly, ensure the free vibration of the convey-
or at each plate height variation.
3
2
CHAPTER
REVISION
5.8
Remove the cutting deck.
Remove the rear wheels.
Loosen the two nuts (11).
Remove the screws (12) and the spacers (13), oper-
ating from inside the outlet, and remove the front part
of the conveyor (14).
1
11
On assembly, ensure the free vibration of the convey-
or at each plate height variation.
Refit the rear wheels.
Reassemble the cutting deck.
FROM ...
PAGE
0
2018
1 of 1
B) Front
14
13
12