Panel-Mount Assembly; Figure 5-13 Bcd Option Board - Omega DP461-S User Manual

S1
A

5.2.5 PANEL-MOUNT ASSEMBLY

The meter can be mounted in a panel so that the front of the meter is flush
with the vertical panel surface. Panel mounting can be seen as simply
"sandwiching" the panel between the inner case and the outer sleeve in the
last phases of assembly. Figure 5-14 shows the panel cutout dimensions,
and the dimensions for the panel thickness. It requires that the following
already be done:
1. Your line voltage rating has been checked against the meter rating on
the Product ID and serial number label on the meter case. See Section
5.2.1.
2. You have configured all jumpers–those on the main board as well as
those on any optional boards. See Section 5.2.2 for main board jumper
configuration and the appropriate sections for optional board jumper
configuration.
3. You have installed all optional boards and inserted the main board
assembly back into the case. See Section 5.2.3.
4. You have wired P1, the AC power connector, and P2 the input output
control connector; connectors are not installed in the meter, but are
ready to be installed. See Section 7.
5. You have wired all connectors for optional boards; connectors are not
connected to the meter, but are ready to be installed.
If all of these steps are done, use Figure 5-14 as a guide:
CAUTION: Connectors with the wiring connections will be installed after
mounting the unit.
S4
A B
S2
A
J8
U1
Figure 5-13. BCD Option Board
S5
A E
C G
S6
B
A
S3
A
A B
B
L1
Setup
A
B
S8
J20
PIN 1
S7
5
5-11