Omega DP461-S User Manual page 90

8
Scaling to
Display
Engineering
Units
again press the 'MAX' button to make your selection. After making
all of your choices, in submenu 1, enter these selections by pressing
the 'MENU' button which will momentarily flash "STORED", on
the display. If the item selected in submenu 1 has a submenu 2
associated with it, press the 'MIN' button to enter the submenu 2.
Select your choice by pressing the 'MAX' button and enter your
choice by pressing the 'MENU' button.
Pressing the 'RESET' button one time brings you back one menu item,
pressing the 'RESET' button two times returns you to the run mode
WARNING! this also results in a hard reset of your peak and valley
and setpoints.
Proceed through the flow chart below entering the values listed in
submenu 1 and 2 columns.
MENU SUBMENU 1 SUBMENU 2 DESCRIPTION
L1CNF
L2CNF
L3CNF
L4CNF
INPUT BRIDGE
RDG.CNF RDG.1=0
RDG.2=0
RDG.3=0
RDG.4=1
RDG.5=
RDG.6=
RDG.7=0
RDG SC 1.00000
RDG OF 0000000
Skip past
Skip past
Skip past
Skip past
Meter's input
2-point scaling IN.SC.OF
Active decimal point
Normal display brightness
Leading zeros suppressed.
Disregard not used
Disregard not used
External hard reset
vs only peak reset
Preset for IN.SC.OF
Preset for IN.SC.OF
8-46
continued next page