Table of Contents
Advertisement
3.0
MECHANICAL ASSEMBLY AND INSTALLATION
3.1
PANEL MOUNTING
1. Remove the main board edge connector (J1) if installed.
2. Use a #8 Phillips-head screwdriver to loosen the two screws on the rear of
the case until you can rotate the two clamp rings. Loosen the screws enough
to allow for the panel thickness.
3. Slide the two slide retainers towards the rear of the unit and remove them.
4. Observe the case dimensions previously shown. From the front of the panel,
insert the meter into the panel cutout.
5. Slide the slide retainers back onto the case and push up tightly against the
rear of the panel.
6. Rotate the clamp rings back into their original position and tighten until the
case is held in place. Do not overtighten.
7. Reinstall any connectors that were removed
Figure 3-1 DIN Case Dimensions
4
Advertisement
Table of Contents
